- 1). Start the generator and run it until it warms up.
- 2). Turn off the generator and remove the oil drain hose from its spring loaded mounting clip.
- 3). Remove the cap from the end of the oil drain hose and let the oil drain into your container. Hold the hose until all the oil has drained out.
- 4). Replace the cap on the end of the drain hose, and return it to its mounting clip.
- 5). Remove the oil filter by turning it counterclockwise.
- 6). Put a light coating of oil on the gasket of your new oil filter to make a better seal.
- 7). Screw the new filter on by hand. After the gasket makes contact, tighten it no more than a full turn. Do not use any tools.
- 8). Fill the engine with new oil. (The amount and grade depend upon your generator size and the temperature in which it operates.)
- 9). Start the generator and let it run for one minute. Turn it off and check for leaks.
- 10
Check the oil level with the dipstick and add more if necessary, but do not overfill.
Source...