Society & Culture & Entertainment
Society & Culture & Entertainment & Religion & Spirituality Information Information
How to Make a Skeg for a Kayak
- 1). Research skeg shapes on the Internet and estimate the size you need. If you frequently kayak in very strong currents and winds, you may want a larger skeg. The disadvantage of a larger skeg is that it can jam more easily, especially in sand. Reviewing the various shapes of commercial skegs and skegs on kayaks similar to yours will help you decide the correct shape and size.
- 2). Cut the skeg following your measurements. Sand lightly to smooth it. If you are using wood, seal it with the oil-based sealant.
- 3). Attach the male end of the channel to the kayak and the female end to the skeg. If desired, use adhesive as well as screws. Slide the female end into the male end. The skeg is attached.
- 4). Add a cable control system. Locate the slider tubes in the skeg box where the cables can be run to the cockpit. Trim the stainless steel wire to have a sharp end and start sliding it through the tubes until it comes out in the cockpit. Attach the cables to the outside tip of the skeg by drilling a small hole and threading the wire through it. If you do not have slider tubes, you can install the cables over the deck of the kayak, being sure to attach the cable tightly to the outside of the kayak by threading it through several small screw eyes.
- 5). Seal all screws and holes using silicone or epoxy.
Source...