- 1). Orient the paper with the long edge facing you. Fold the top edge down to the bottom.
- 2). Repeat, folding the upper edge down to the bottom of the paper. Fold again to make a thin strip.
- 3). Repeat the previous steps with a second piece of paper.
- 4). Fold one of the strips in half. Unfold the piece, then measure and mark about an inch from the crease.
- 5). Fold the end of the paper straight down, so it forms a 45-degree angle at the mark you made.
- 6). Refold the piece along the half-line, and fold the other end of the piece along that angle. Lift the upper flap so that the new fold goes inside the model.
- 7). Unfold the center crease and re-fold it in the opposite direction.
- 8). Fold the remaining strip in half along the center crease. This piece becomes the barrel of the gun.
- 9). Slide the barrel of the gun into place on the rest of the gun. Put the open ends of the barrel around the longer edges of the handle piece, and then slide them inside the center section of the trigger.
Source...